• R. Srikanth
• Y. Karthik
• B.Rohith
• G. saikiran
• B.Syamprasad

Abstract: This paper's primary goal is to provide a thorough design calculation and analysis of the go-kart vehicle parts. A go kart is a three-wheel vehicle in which both of the rear tyres rotate at the same speed because it lacks a differential and suspension. The goal of this research is to model and analyse go-kart vehicle components using design calculations and part simulations. Impact analysis was carried out in the front, rear, and lateral directions with SOLIDWORKS 2016 for modelling and analysis, and ANSYS WORKBENCH 16.2 for simulation. Next, we looked at the deformation of the chassis and the flexural rigidity of the structure. After comparing the outcomes of two distinct materials, the qualities with the finished design are finished. The design stresses and deformation results of several car part components, include[Ping the disc brake's temperature analysis and the stub axle and stub arm of the steering system, are presented in this study. The design is adjusted in accordance with the findings of these tests.

"DESIGN AND FABRICATION OF PEDAL OPERATED THREE WHEEL GO KART", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 4, page no.n75-n83, April-2024, Available :http://www.jetir.org/papers/JETIR2404D11.pdf

"DESIGN AND FABRICATION OF PEDAL OPERATED THREE WHEEL GO KART", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 4, page no. ppn75-n83, April-2024, Available at : http://www.jetir.org/papers/JETIR2404D11.pdf