UGC Approved Journal no 63975(19)
New UGC Peer-Reviewed Rules

ISSN: 2349-5162 | ESTD Year : 2014
Volume 12 | Issue 10 | October 2025

JETIREXPLORE- Search Thousands of research papers



WhatsApp Contact
Click Here

Published in:

Volume 12 Issue 2
February-2025
eISSN: 2349-5162

UGC and ISSN approved 7.95 impact factor UGC Approved Journal no 63975

7.95 impact factor calculated by Google scholar

Unique Identifier

Published Paper ID:
JETIR2502018


Registration ID:
554778

Page Number

a125-a135

Share This Article


Jetir RMS

Title

To analyze the structural audit for structural assessment and strengthening of fire affected structures

Abstract

In India specifically in Metro Cities the residential and commercial buildings construction rapidly increases. The mass of Population and several commercial area are associated in comparatively small area due to land rate and other reasons in metro cities .But due to quite a lot of reasons either manmade and natural theses structure affected by disaster .Fire is one of the major source of such kind of disaster in metro cities because if these kind of fire disaster use of that structure is not to be done by occupants due to these the financial loss may take place and it is also not economical to demolish the buildings and build a new building. To avoid the loss the buildings structural audit is necessary to check its structural stability after fire disaster and the strengthen of building by appropriate method is very much essential After a fire incident the first question from a structural point of view is whether the construction can be refurbished or, in extreme cases, needs to be replaced. The choice of action must be based on an assessment of the status of the structure. This assessment is in turn based on a mapping of damage to the construction. The mapping of damage needs to be accurate to optimise both the safety level and the best solution from an economic point of view. The traditional assessment methods included in the experimental part of the research are: rebound hammer, ultrasonic pulse measurements and microscopy methods. These are compared to optical full-field strain measurements during a compressive load cycle on drilled cores, i.e. the new method proposed to determine the degree of damage in a fire exposed cross-section. Based on the results from the present study an approach with two levels of complexity is recommended. The initial level is to perform an inspection and determine the development, size and spread pattern of the fire .In this research initially study the different NDT techniques. Then next phase the in situ assessment of fire affected building by taking suitable case studies and evaluated the actual structural damage of building and appropriate method for strengthen of building will be suggested by studying the cost effectiveness of each method

Key Words

In situ, Assessment, Structure, Audit, NDT, rebound Hammer strengthen

Cite This Article

"To analyze the structural audit for structural assessment and strengthening of fire affected structures", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.12, Issue 2, page no.a125-a135, February-2025, Available :http://www.jetir.org/papers/JETIR2502018.pdf

ISSN


2349-5162 | Impact Factor 7.95 Calculate by Google Scholar

An International Scholarly Open Access Journal, Peer-Reviewed, Refereed Journal Impact Factor 7.95 Calculate by Google Scholar and Semantic Scholar | AI-Powered Research Tool, Multidisciplinary, Monthly, Multilanguage Journal Indexing in All Major Database & Metadata, Citation Generator

Cite This Article

"To analyze the structural audit for structural assessment and strengthening of fire affected structures", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.12, Issue 2, page no. ppa125-a135, February-2025, Available at : http://www.jetir.org/papers/JETIR2502018.pdf

Publication Details

Published Paper ID: JETIR2502018
Registration ID: 554778
Published In: Volume 12 | Issue 2 | Year February-2025
DOI (Digital Object Identifier):
Page No: a125-a135
Country: Pen, Maharashtra, India .
Area: Engineering
ISSN Number: 2349-5162
Publisher: IJ Publication


Preview This Article


Downlaod

Click here for Article Preview

Download PDF

Downloads

000204

Print This Page

Current Call For Paper

Jetir RMS