• DR. RAKESH VERMA
• RAJESH KUMAR
• RAVI SHUKLA
• AKASH BAJPAI
• C.S .AZAD

Cutting fluid is a vital element in a machining processes and is used to remove heat and reduce friction thereby enhancing a number of important economic as well as quality parameters like cutting tool life and surface finish. However it also has an impact on manufacturing cost, ecological damages and occupational health problems and these coupled with global trend of low cost and high productivity hinder the use of wet machining processes. Near dry machining as a substitute for flood cooling is an eco-friendly process that uses minimum amount of cutting fluid and with OoW-concept it is becoming more effective. The understanding of effectiveness mechanism of near dry machining based on Rebinder Effect is important to analyze and understand both qualitative and quantitative aspects of process parameters in machining.

Cutting Fluid, Minimum Quantity Lubrication, Aerosol, Oil on Water, Rebinder Effect.

" Analysis Of Near Dry Machining Using Minimum Quantity Lubrication-A Technical Review.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.12, Issue 12, page no.a246-a251, December-2025, Available :http://www.jetir.org/papers/JETIR2512032.pdf

" Analysis Of Near Dry Machining Using Minimum Quantity Lubrication-A Technical Review.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.12, Issue 12, page no. ppa246-a251, December-2025, Available at : http://www.jetir.org/papers/JETIR2512032.pdf