• Khule Yogesh
• Badhe Sagar
• Gadge Avinash
• Todkar Shubham
• Pabale Kshitij

Now a days every one want to reduce the cost and time required for manufacturing of any product. Grinding operation is performed to obtain a fine surface finish in this project we are use this grinding process for resharpening of industrial HSS cutter and we replace the machine by direct attachment on lathe machine which is available in industry, so reduction of cost for resharpening and machine. The component designs to use in this project are base plate, induction Motor, Sleeve, stud, nut and bolts. Motor is attached to lathe tool post by using base plate and rubber pad and job is attached on center of lathe by using supporting shaft and tilting angle is given by swiveling base plate. Grinding wheel is attached on motor by using sleeve and bolt for fitting.

Grinding Attachment, Surface Finishing, grinding wheel, motor.

"Fabrication of Grinding Wheel Attachment for Lathe Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 2, page no.121-124, February-2019, Available :http://www.jetir.org/papers/JETIRAE06027.pdf

"Fabrication of Grinding Wheel Attachment for Lathe Machine", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 2, page no. pp121-124, February-2019, Available at : http://www.jetir.org/papers/JETIRAE06027.pdf