• Saurabh Dilip Pophali
• Prof. Kunal R. Ghadge

In this mini project a boiler shed is analyzed and designed. The shed is designed in two ways. Firstly conventional truss is used and it is designed. Then using tapering sections (Pre-engineer) boiler shed is designed. Analysis of both type of shed is done by STAAD Pro. The steel boiler shed design is as per the clauses and norms specified by IS 800-1984, IS: 875- Part I, IS: 875-Part II, IS: 875-Part III. Designing is done using various load combinations. Designing is done in 2D as well as 3D. A scaled model of the 2D and 3D conventional truss as well as pre-engineered buildings was prepared. Purpose of this project is to understand the design of pre-engineered buildings as well as to study the advantages of conventional structures over pre-engineered building. The obtained numerical results are used to study of advantages of conventional structures over pre-engineered buildings. The variations in some of the results may be attributed to practical limitations of designing procedures. The validated software models are further used in parametric study includes determination of weight of the members. The weight of members can be used to determine the cost of building of conventional as well as pre-engineered buildings. This parameter can also be used to determine the requirement of material and accordingly cost can be determined.

Pre-Engineered, conventional, staadpro, design

"COMPARATIVE STUDY OF ANALYSIS AND DESIGN OF PRE-ENGINEERED AND CONVENTIONAL INDUSTRIAL BUILDING BY USING SUITABLE SOFTWARE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 4, page no.317-320, April-2019, Available :http://www.jetir.org/papers/JETIRBD06060.pdf

"COMPARATIVE STUDY OF ANALYSIS AND DESIGN OF PRE-ENGINEERED AND CONVENTIONAL INDUSTRIAL BUILDING BY USING SUITABLE SOFTWARE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 4, page no. pp317-320, April-2019, Available at : http://www.jetir.org/papers/JETIRBD06060.pdf