• Mr. Mosam M. Dange
• Dr. S. R. Ikhar
• Er. V. D. Dhopte

The paper is about fabrication of coating powder filtration machine. Coating powder is mainly used to coat the job in various manufacturing industries. After coating the job some amount of powder has been wasted, while it is necessary to prevent this powder for further reused. So the powder coating filtration machine is mainly focused on the reused of coating powder and save some amount of powder which leads to cost effective. After that the amount of powder which is save filter by using sieving process This mechanism is based on cyclone and sieving process which plays an important role in mechanism. Cyclone is one of the simplest and cheapest type of separator. Cyclone has high efficiency and relatively economic in power. Cyclone have been widely used in industrial process. The literature review that the cyclone efficiency is depends upon the size of the particle of powder. The input velocity of air directly impact on the fan energy and powder collection. This paper have discussed the process of powder extracting from manual powder spray booth in the first chamber with a cyclone recovery system. The cyclone cleaned air drawn from pre filter section by fan. The pre filter section further separate powder from cyclone air. Collection of powder without loss of coating powder and filter the coating powder by using sieving process with less time consumption

"DESIGN AND FABRICATION OF COATING POWDER FILTRATION MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.173-177, May-2019, Available :http://www.jetir.org/papers/JETIRBQ06030.pdf

"DESIGN AND FABRICATION OF COATING POWDER FILTRATION MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp173-177, May-2019, Available at : http://www.jetir.org/papers/JETIRBQ06030.pdf