• P. R. Gajbhiye
• Rahul Pache
• Prashant Gawalkar
• Pranay Borkar

Construction of buildings requires sand as an important ingredient Sand is used at different stages in construction right from the foundation to the finishing work i.e. plaster. This sand is needs to be screened properly for various stages in construction, i.e. size of sand for construction work is slightly coarse whereas that used for plaster work is fine. Conventionally screening is normally done manually using fixed screens or machines. This manual process time consuming and laborious takes a lot of time and cost. It is also observed that the conventional machine prove of no or little help as the sand needs to be manually transported and material handling takes place twice to get different sizes of sand1. These processes are carried out manually. Sieving of sand is carried out using rectangular mesh which is inclined at certain angle. This causes a relative motion between the particles and the sieve. Depending on their size the individual particles either pass through the sieve mesh or retained on the sieve surface. There are different machines that are being used for sand sieving processes. In our project the process will takes place automatically. Thus the time consumed during the whole process of preparing the concrete is reduced.

Sieve machine, Characterizing, Design, Fabrication, Ergonomic design

"STUDY AND DESIGN PARAMETER OF SAND SCREENING MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.219-223, May-2019, Available :http://www.jetir.org/papers/JETIRBQ06039.pdf

"STUDY AND DESIGN PARAMETER OF SAND SCREENING MACHINE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp219-223, May-2019, Available at : http://www.jetir.org/papers/JETIRBQ06039.pdf