• P.C.Ganga Raju
• B.Naga Raju
• P.Lalith Krishna
• G.Chetan
• D.Manoj

The necessity of aluminium based composites in the fields of Automobile, Aerospace, Electrical was started due to high Strength, Hardness and Stiffness at low weight. The commonly used reinforcements for aluminium are SiC, Al2O3, graphite etc. By the addition of ceramic particles to aluminium increases strength, hardness remarkably. In this study SiC and Al2O3particles were taken as reinforcement and mixed with Al 6061 by using stir casting technique. Experimental tests such as tension, hardness were conducted on composite samples, base metal and those values are compared. In the microstructure of composite samples, uniform distribution of reinforced particles was observed by conducting scanning electron microscope (SEM).

Composites, Ceramic particles, Reinforcements, Stir casting, SEM etc.

"FABRICTAION AND CHARACTERISATION OF SIC AND AL2O3 PARTICLES REINFORCED AL6061 METAL MATRIX COMPOSITIES", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.218-222, May-2019, Available :http://www.jetir.org/papers/JETIRBT06031.pdf

"FABRICTAION AND CHARACTERISATION OF SIC AND AL2O3 PARTICLES REINFORCED AL6061 METAL MATRIX COMPOSITIES", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp218-222, May-2019, Available at : http://www.jetir.org/papers/JETIRBT06031.pdf