• Ashelsha Bansod
• Neha Shende
• Akshay Kamble
• Nilesh Korode
• Roshan Khandare

Transformer test panel has many functions, which may be used independently or simultaneously for different purpose and on this panel we perform some tests. For this panel single phase transformer is used. Open circuit test is performed to determine the iron losses or no load losses of the transformer during this test secondary side or high voltage side of the transformer is open circuited. Short circuit test is performed to determine the copper losses of the transformer. During short circuit test secondary side or low voltage side of the transformer is short circuited by thick wire. Back to back test is performed to determine the open circuit test and short circuit test at same time thus to find the temperature rise of the transformer when transformer is fully loaded. By using this readings we are going to find this all parameters of open circuit test and short circuit test and sumpner’s test automatically by using aurdino programming. Panel will give us correct and accurate results by using digital meters, panel will reduce the time required for calculations and connection, panel is safe and efficient

FABRICATION OF SINGLE PHASE TRANSFORMER TEST PANEL

"FABRICATION OF SINGLE PHASE TRANSFORMER TEST PANEL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.193-195, May-2019, Available :http://www.jetir.org/papers/JETIRBV06041.pdf

"FABRICATION OF SINGLE PHASE TRANSFORMER TEST PANEL", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp193-195, May-2019, Available at : http://www.jetir.org/papers/JETIRBV06041.pdf