• Rahul Pattar
• Shubham Angadi
• Dileep Kumar
• Jummanna Bhangi
• Srinivas S

Vehicles are commonly used around the world particularly in INDIA. The gear shifting mechanism of the motor-cycle is used manual. This work covers development of an indigenous gear shifting /changing system for all methods of motorcycle. By this system the mechanical gear shifting will remain unchanged because an additional electromagnetic valves system is placed on top of the lever, to shift the gear and automatically control the clutch. Electromagnetic valves made up of solid copper wire. By using this system accurate control of the vehicle is achieved by varying the speeds. A wiper motor is used to control the position of the clutch. Hardware, Software and testing of the electromagnetic valve are verified. System is flexible and can be used with any motorcycle having manual transmission system. In this work the expected force for each electromagnetic valve was found to be 38.423 N. The effectiveness in gear operation between manual and electromagnetic valve were exactly the same and hence this reduced the human effort.

Electromagnetic valves, Wiper motor, Relay, Speed sensor, Gear etc …..

"DESIGN AND FABRICATION OF AUTOMATIC GEAR SYSTEM USING ELECTROMAGNETIC VALVES", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.377-384, May-2019, Available :http://www.jetir.org/papers/JETIRBZ06059.pdf

"DESIGN AND FABRICATION OF AUTOMATIC GEAR SYSTEM USING ELECTROMAGNETIC VALVES", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp377-384, May-2019, Available at : http://www.jetir.org/papers/JETIRBZ06059.pdf