• Sounak Majumder
• Rajdeep Sardar
• Prishat Bachhar
• Pranibesh Mandal

Cooling of hot steel sheets under air-water mixture jet is carried out in steel industries in Run Out Tables (ROTs). In general, higher jet flow rates are required to get higher cooling rates. Studies have been conducted till date to get different cooling rates for achieving various microstructures of steel. However, all these have been concentrated for higher jet flow rates. Experimental study of getting cooling rates under lower air flow rates is thus a requirement. This may result in achieving some new microstructure. The present study carries out the same observation under a number of air jet flow rates of lower values in order to observe the cooling rate of an MS plate under the same in a laboratory scale ROT.

air jet , lower air flow rate, Run Out Table

"EXPERIMENTAL STUDY OF COOLING RATE VARIATION UNDER LOW AIR JET FLOW RATE IN A LABORATORY SCALE ROT", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 5, page no.120-122, May-2019, Available :http://www.jetir.org/papers/JETIRCA06024.pdf

"EXPERIMENTAL STUDY OF COOLING RATE VARIATION UNDER LOW AIR JET FLOW RATE IN A LABORATORY SCALE ROT", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 5, page no. pp120-122, May-2019, Available at : http://www.jetir.org/papers/JETIRCA06024.pdf