• Abhishek N
• Mounish K Kumar
• Vaishak S
• U Shalok Gangatakar
• Dr Shamanth

This study has been undertaken to investigate the tensile behavior of Al Mg₁₀ Si alloy produced by direct metal laser sintering process and A360 alloy by die casting method. The next industry revolution is widely predicted to be additive manufacturing, with an evolution of autonomous and electric vehicles, the need for light weight material will be the primary focus without compromising on the performance. One such potential technology can be addressed by metal additive manufacturing which is commonly known as metal 3D Printing. Additive manufacturing gives more space to complex design and scope intuitive as it poses fewer manufacturing constraints when compared to traditional casting techniques. As we know that aluminum alloys are one of the primary materials used for producing such lightweight components and direct metal laser sintering (DMLS) has one such potential manufacturing technology. In this study, one set of specimens were 3D printed by DMLS technique and other set of specimens were produced by using die casting technique for evaluating the tensile properties. Superior mechanical behavior and better strength to weight ratio were observed for the 3D printed samples.

Additive manufacturing, DMLS, Al Mg₁₀ Si alloy, Tensile Properties, A360 alloy and Die casting.

"Comparison Studies On Tensile Behavior of Al Mg₁₀ Si Alloy Produced by DMLS & A360 Alloy By Die Casting Method", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 7, page no.207-210, July-2021, Available :http://www.jetir.org/papers/JETIREX06032.pdf

"Comparison Studies On Tensile Behavior of Al Mg₁₀ Si Alloy Produced by DMLS & A360 Alloy By Die Casting Method", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 7, page no. pp207-210, July-2021, Available at : http://www.jetir.org/papers/JETIREX06032.pdf