• Abhishek Gurav
• Prathamesh Khalipe
• Sourabh Madane
• Rohit Patil
• Ghansham Firame

Precision measurement of gears plays a vital role in gear measurement and inspection. The current methods of gear measurement are either time consuming or expensive. In addition, no single measurement method is available and capable of accurately measuring all gear parameters while significantly reducing the measurement time. The aim of this paper is to utilize the computer vision technology to develop a non-contact and rapid measurement system capable of measuring and inspecting most of spur gear parameters with an appropriate accuracy. A vision system has been established and used to capture images for gears to be measured or inspected. The introduced vision system has been calibrated for metric units then it was verified by measuring two sample gears and comparing the calculated parameters with the actual values of gear parameters. For small gears, higher accuracy could be obtained and as well as small difference.

Gear Inspection, Accuracy, Spur Gears, Conveyer System, Image Processing.

"Design And Manufacturing of Automatic Gear Inspection Conveyor System for Quality control By Using Image Processing.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.10, Issue 5, page no.759-764, May-2023, Available :http://www.jetir.org/papers/JETIRFX06135.pdf

"Design And Manufacturing of Automatic Gear Inspection Conveyor System for Quality control By Using Image Processing.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.10, Issue 5, page no. pp759-764, May-2023, Available at : http://www.jetir.org/papers/JETIRFX06135.pdf