• K.Suresh kumar
• Dr.K.R.Dinesh
• Dr.K.Veeresh
• Dr.Jagadish.S.P

In this research work the Investigation of Tool Wear and Tool Life with Optimization of parameters on different tool alloys on S1(SS316),S2(SS304),S3(SS410),S4(SS440C),S5(HSS),S6Titanium alloy gradeS6 (Ti-6Al-4V) Tool material ,Workpiece material ,Max. Time elapsed(in min.)Flank wear(in mm),Wear rate m/min For mild steel workpiece material at low cutting speed the shear force of the SS440C(S4) material is high as compared to the HSS(S6) tool.For aluminium workpiece material, at lower cutting speed SS316(S1) has a greater Shear force than the Titanium alloy (Ti-6Al-4V) (S5), but at higher cutting speeds Titaniumalloy(Ti-6Al-4V)(S5 )was found to have higher Shearforce than SS316(S1).For mild steel workpiece material, at all cutting speeds tool life of HSS (S6) and SS440C(S4) was found to be relatively close.For aluminium workpiece material, at all speeds Titanium alloy (Ti-6Al-4V) (S5) was found to be having longer tool life than SS316(S1) and (Ti-6Al-4V) S5 tool cost is very high compare to other tools (S6) (S4)(S3) (S2)(S1). Finally the cutting tool Titanium alloy (Ti-6Al-4V) (S6) HSS (S5) is good compare to other alloy materials.

S1(SS316),S2(SS304),S3(SS410),S4(SS440C),S5(HSS),S6Titanium alloy gradeS6 (Ti-6Al-4V) Tool material, Optimization of parameters

"Investigation of Tool Wear and Tool Life with Optimization of parameters on different Cutting tool alloys ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.11, Issue 1, page no.338-357, January-2024, Available :http://www.jetir.org/papers/JETIRGB06045.pdf

"Investigation of Tool Wear and Tool Life with Optimization of parameters on different Cutting tool alloys ", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.11, Issue 1, page no. pp338-357, January-2024, Available at : http://www.jetir.org/papers/JETIRGB06045.pdf