• R Naveenkumar
• Dr. Manjunath H V
• Arun Kumar S

IPV6 over low power personal area network is abbreviated as 6LoWPAN basically designed for high bandwidth infrastructure with mesh topology. The 6LoWPAN standard RFC 4944 was deployed by organization called Internet Engineer- ing Task Force (IETF) which carries IP packets over IEEE 802.15.4 networks. This module is deliberated for low data rate communication (250kbps) of devices with short range distance (10m to 100m) having the highest degree of reliability. It can be operating in a point-to-point or point-to-multipoint network and also supports virtually illimitable number of nodes in a network. The 6LoWPAN module powered up by 3.3 V with Texas Instrument CC1310 micro-controller with frequency range sub-1 GHz. In 6LoWPAN module provides different low power modes to save energy in battery operated devices. This paper mainly focuses on power calculation for different mode like active mode, sleep mode, run mode, idle mode of 6LoWPAN module and Functional test for different peripheral interfaces on designed module. Schematic of each component in the 6LoWPAN is designed using software Cadence Redon 16.3 with tool PCB Allegro design entry. By using the design, we estimated the total input and output power required for each compound. Finally, total Power losses is calculated during the active mode of each component for 70% of efficiency.

6LoWPAN, Sub-1GHz MCU, PCB, Functional test, Power loss, functional test

"Design of 6LoWPAN module for IoT communication", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.608-612, June-2019, Available :http://www.jetir.org/papers/JETIR1906527.pdf

"Design of 6LoWPAN module for IoT communication", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp608-612, June-2019, Available at : http://www.jetir.org/papers/JETIR1906527.pdf