• Ramesh Pal
• Prof. Kapil Soni
• Prof. Harsh Panthi

The effective uses of a pine wood are limited at its maximum strengthening limits. The study was conducted by using the experimental approach. The major study was done on pine wood by using polycarbonate reinforced polymer and epoxide reinforced polymer with different thickness i.e. 10mm, 15mm, 20mm, 25mm, A factor of safety was analyzed by performing experimental investigation. In our analysis, pine wood sample was used and the reinforced polymer was laminated on the surface of pine wood of rectangular cross – section, In order to verify the sample, the critical buckling with their deformation by using different reinforced polymer with different thickness are compared with the available experimental results. The results show that increasing thickness of reinforced polymer increases radius of gyration and factor of safety for each location of coated pine wood sample and decreases the slenderness ratio with increase in a thickness simultaneously. The factor of safety of the coated pine wood is compared by using four types of thickness i.e. 10mm, 15mm, 20mm, 25mm of optimized coated pine wood for various thickness of polymer.

Internal Combustion Engine Fins, Temperature Distribution, Surface Area of Fin, Fillet in Fin. Buckling, Factor of Safety, Allowable stresses

"EXPRIMENTAL INVESTIGATION IN PINE WOOD LAMINATED WITH REINFORCEMENT POLYMER TO ANALYZE STRENGTH AND FACTOR OF SAFETY", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.6, Issue 6, page no.833-840, June 2019, Available :http://www.jetir.org/papers/JETIR1907C78.pdf

"EXPRIMENTAL INVESTIGATION IN PINE WOOD LAMINATED WITH REINFORCEMENT POLYMER TO ANALYZE STRENGTH AND FACTOR OF SAFETY", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.6, Issue 6, page no. pp833-840, June 2019, Available at : http://www.jetir.org/papers/JETIR1907C78.pdf