• Saurabh Rajendra More
• Dr. Kuldeep Dabhekar
• Manish Lende
• Dr. Isha P Khedikar

Plastic waste which are frequently used in our daily life for various purposed accounts for a leading waste in today’s Era. Indian agriculture is also based on plastic like pipes, pump and other agriculture equipments which contributes in total solid plastic waste. This waste plastic can be reduce, recycled and reused to avoid land pollution, water pollution and air pollution. Natural river bed sand resources are being consume from the various sources and Indian government has press control on the use of natural sand from the rivers. As an alternative to natural sand is artificial sand but again it is obtained from crush rocks. These rocks are also our natural assets. Hence, Using waste plastic as an alternative.Important reuse of plastic can be in form of fine aggregates. Waste plastic generated could be crushed and grinded and used partially replacement with the fine aggregates. The current study target to proper utilisation of waste polypropylene as partially replacement to fine aggregate in concrete mix beyond 20%. The present analysis looks at replacement of fine aggregate with plastic waste by 20%, 25% and 30%. Our aim to study the behaviour of concrete with recycled waste plastic as in cubes, cylinders and beams are cast. The properties of concrete using recycled plastic waste are thus established by experimental analysis.

Reused Plastic Waste, Concrete ,Fine Aggregate, Plastic Solid waste, Compressive Strength,Polypropylene Waste, Splitting Tensile, Flexural Test

"Feasibility Study of Partial Replacement of Fine Aggregate with Waste Plastic to Enhancing the Properties Of Concrete.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.7, Issue 9, page no.624-635, September-2020, Available :http://www.jetir.org/papers/JETIR2009084.pdf

"Feasibility Study of Partial Replacement of Fine Aggregate with Waste Plastic to Enhancing the Properties Of Concrete.", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.7, Issue 9, page no. pp624-635, September-2020, Available at : http://www.jetir.org/papers/JETIR2009084.pdf