• Nagavarapu Rohithkumar
• Rupesh tatapudi
• Dayam dany harsha
• Deepak yadav
• sanjeev kumar

This study aims to optimize the mass of the swingarm by using the generative design approach. Reducing the un-sprung mass becomes crucial in designing a performance vehicle and the key method in doing so is by designing a lightweight swingarm to attain lightweight wheel assembly. A conventional design approach is very tedious and many at times lead to dead ends so we are using the generative design approach to reduce the mass of the swingarm. It is a tool which runs on artificial intelligence to develop the component by performing many iterations on the basic design. The tool builds up the material only where it is needed based on the given loads and constrains which are set by us and It also takes care of the material selection and manufacturing methods of the design. In this study we had achieved 49% of mass reduction of the ATV swingarm by using the generative design module in Autodesk fusion 360 software. This study also helps in understanding how to perform the generative design study analysis.

computer aided design, design optimization, fem, swingarm, static structural analysis

"optimization of swingarm design using generative design", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.8, Issue 6, page no.f599-f612, June-2021, Available :http://www.jetir.org/papers/JETIR2106783.pdf

"optimization of swingarm design using generative design", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.8, Issue 6, page no. ppf599-f612, June-2021, Available at : http://www.jetir.org/papers/JETIR2106783.pdf