• Er. Waghoo Parvez
• Dr. Vijay Kumar

The paper presents experimental investigation into optimization of MRR during milling of zirconia ceramic material. Experiments were conducted using three input machining parameters cutting speed, feed and depth of cut at three different levels. Taguchi orthogonal array (OA) L9 was used for performing the experiments. MRR optimization was performed using Taguchi and RSM technique. After optimizing, confirmation test were performed and results of both the test were compared to find better technique. The results led to a conclusion that RSM technique provides better results as compared to Taguchi technique.

MRR, RSM, cutting speed, feed, depth of cut.

"OPTIMIZATION OF MATERIAL REMOVAL RATE (MRR) IN MILLING OF ZIRCONIA CERAMIC MATERIAL USING TAGUCHI AND RESPONSE SURFACE METHODOLOGY (RSM) TECHNIQUE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org), ISSN:2349-5162, Vol.5, Issue 7, page no.100-103, July-2018, Available :http://www.jetir.org/papers/JETIRA006017.pdf

"OPTIMIZATION OF MATERIAL REMOVAL RATE (MRR) IN MILLING OF ZIRCONIA CERAMIC MATERIAL USING TAGUCHI AND RESPONSE SURFACE METHODOLOGY (RSM) TECHNIQUE", International Journal of Emerging Technologies and Innovative Research (www.jetir.org | UGC and issn Approved), ISSN:2349-5162, Vol.5, Issue 7, page no. pp100-103, July-2018, Available at : http://www.jetir.org/papers/JETIRA006017.pdf